The following example shows output from the config terminal command:
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)#
Configuration Mode Commands and Submodes
Here is a list of configuration mode commands:
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)#
| aaa | Configure the aaa |
| arp | “no” remove an entry from the ARP cache |
| boot | Configure the boot variables |
| callhome | Enter the callhome configuration mode |
| clock | Configure the time-of-day clock |
| end | Exit to EXEC mode |
| exit | Exit from the EXEC |
| fcalias | Fcalias configuration commands |
| fcanalyzer | Configure the fabric analyzer |
| fcc | Configure the fc congestion control |
| fcdomain | Enter the fcdomain configuration mode |
| fcdroplatency | Configure the switch or network latency |
| fcflow | Configure the fcflow |
| fcinterop | Interoperate commands |
| fcns | Name Server configuration |
| fcroute | Configure the FC routes |
| fcs | Configure the Fabric Config Server |
| fctimer | Configure the fibre Channel timers |
| fspf | Configure the fspf |
| interface | Select an Interface to Configure |
| line | Configure a terminal line |
| logging | Modify the message logging facilities |
| no | Negate a command or set its defaults |
| ntp | NTP Configure |
| power | Configure the Power supply |
| poweroff | Power off a module in the switch |
| qos | Configure the priority of FC control frames |
| radius-Server | Configure the RADIUS related parameters |
| role | Configure the Roles |
| snmp-server | Configure SNMP server |
| span | Enter SPAN configuration mode |
| ssh | Configure the SSH parameters |
| switchname | Configure the system’s network name |
| system | System config command |
| telnet | Enable the telnet |
|
trunk |
Configure the switch wide trunk protocol |
| username | Configure the user information |
| vsan | Enter the vsan configuration mode |
| zone | Zone configuration commands |
| zoneset | Zoneset configuration commands |
| ip | Configure the IP features |